The RD2432 wireless output module utilizes reliable Spread Spectrum Mesh Network Radio technology. Together with other Trs wireless transceiver (BACnet, LonWorks & MODBUS), the system can be used to transmit remote control signals wirelessly. It is compatible with any control systems or DDC panels that accept 0-10 VDC or 0- 5 VDC inputs.

The maximum radio transmission distance is dependent on building type. The maximum open- air transmission distance is one mile. In a typical commercial building with steel I-beam construction, concrete floors with reinforcing rod, and metal stud walls, it can be expected that transmissions will penetrate vertically through floors and horizontally through 200 to 500 feet of walls, furniture and air.

Generally a wireless system will cover at least three floors - one floor above and one floor below the output module location. In some buildings with favorable transmission characteristics the system may cover more floors.

Wireless transceiver or repeaters should be installed within 200 to 500 feet of the RD2432 output module.

RR2552 signal repeaters can be installed as needed to increase transmission distance between transceiver and output modules.

Input Power:
  24 VAC 60 Hz, 300 mA nominal
  24VDC, 300 mA nominal

  8.8” x 4.7” x 2.25”

Operating Conditions:
  Temperature -40 to 150 deg F
  Humidity 5 to 95% non-condensing

  Flame Retardant ABS Plastic (Black)
  UL Flame Rating – 94-5VA

Four Analog Output Channels:
  0 – 10 VDC or 0 – 5 VDC
  Minimum controller input resistance should be greater than 20 KOhm
  100 ft. maximum wiring distance to controller

Four Digital Outputs:
  Pilot Duty Relay Contact Closure
  Contact Rating – 1 A at 24VAC Max.

One Low Battery/Lost Sensor Alarm:
  Pilot Duty Relay Contact Closure
  Contact Rating – 1 A at 24VAC Max.

RF Characteristics:
  Operating Frequency Channel 902-928 MHz
  Receiver Sensitivity (avg. power) –110 dBm

  FCC Certified